Series illustrations. Actual configuration is subject to the confirmed drawing.
NEMA 5-15P to IEC C5 Cloverleaf Laptop Power Cord, 0.5m 18AWG SVT Copper PVC 10A 125V Black or White
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
End connectionIEC C5
-
Cable Length0.5 m(1.64ft)End TypeC5
-
Rated Current10 ATypeAc Power Cord
-
ApplicationConsumer Electronics
-
Female End TypeIECIP LevelIP11
-
Male End TypeNemaMaterialCopper, PVC
-
Wire TypeSVT
A short laptop power-unit connection still needs the correct connector at both ends. This US NEMA 5-15P to IEC C5 cloverleaf cord combines a 0.5m reach with 18AWG SVT copper/PVC construction and a 10A, 125V designation.
Black and white configurations are available for the same compact equipment-lead arrangement. Select the required color while retaining the actual connector and electrical requirements.
Check the cloverleaf equipment inlet
The C5 end must mate with the receiving power unit or electronic device. Compare the actual inlet before selecting a replacement, since a laptop or consumer-electronics label alone does not establish the connector needed.
Check the NEMA 5-15P three-prong supply point at the same time. Both connections should be identified before the cord is chosen for the installation.
Use the compact reach deliberately
The defined cable length is 0.5m, approximately 1.64ft. Measure the intended route between the supply point and power unit, including the positions of the connectors.
Keep the 18AWG SVT copper/PVC build with that reach. Those details distinguish this compact lead from a cable selected only by color or general cloverleaf appearance.
Match the complete equipment demand
The electrical designation is 10A, 125V. Compare the receiving equipment requirement with the complete cord rating and the intended supply arrangement before selecting the version.
Include the chosen color, 0.5m route and actual inlet detail in the order specification. This gives a replacement request a defined physical and electrical connection rather than assuming that every power unit uses the same lead.
For a compact installation, confirm the connector forms first and the usable route next. The selected cord can then be matched to the particular equipment being supplied.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
