Series illustrations. Actual configuration is subject to the confirmed drawing.
0.3m One-to-Two IEC Equipment Power Lead, C14 Male to 2x C13 Female Black 0.75mm² Copper SJT 10A Configuration
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
End connectionIEC C13
-
Cable Length0.3 m(0.98ft)End TypeC13
-
Rated Current10 ATypeAc Power Cord
-
ApplicationComputer, Home Appliance
-
Female End TypeIECIP LevelIP11
-
Male End TypeIECMaterialCopper
-
Wire TypeSJT
Compact equipment distribution needs the two receiving positions defined alongside the common source. This 0.3m black lead joins one IEC C14 male end to two C13 female ends using 0.75mm² copper/SJT construction, with a 10A designation.
Map the two equipment positions
Identify where each receiving device will sit in relation to the common supply connection. Describe the actual route needed to each C13 inlet within the compact arrangement.
The 0.3m dimension should remain attached to that layout. Include the positions of all connector bodies when checking the available connection space.
Compare all three mating points
Match the C14 male end to the source used by the installation. Compare both female C13 ends with the actual receiving equipment inlets.
Keep the complete one-to-two connector requirement in the order detail. Each receiving device should be identified so the intended connection is clear at both branches.
Keep the selected conductor build
The cable specification uses 0.75mm² copper with the SJT wire family. Retain that construction with the black finish and compact reach.
The receiver routes and selected cable build belong in one assembly requirement. These details define the physical lead needed before the electrical demand is matched.
Account for the shared incoming demand
Specify the complete operating voltage required with the 10A assembly designation. Check the combined receiving-device demand against the actual supply and ordered lead rating.
Both C13 ends share the C14 incoming connection. Keep that common source in the equipment specification so the compact lead is selected around the complete two-device power path.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
