Series illustrations. Actual configuration is subject to the confirmed drawing.
C19 to C20 3-Pin IEC Male-to-Female Power Cord, 250V Copper Cable for Computer UPS PDU
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
End connectionIEC C20 , IEC C19
-
AC Outlets Quantity1 OutletsCable Length0.5 m(1.64ft)
-
End TypeC19, C20Rated Current16 A
-
TypeExtension Cord
-
ApplicationComputerFemale End TypeIEC
-
IP LevelIP11Male End TypeIEC
-
MaterialCopperWire TypeSJT
A half-metre IEC extension can provide a defined link in a compatible computer, UPS or PDU power path. This black C20-to-C19 lead pairs the three-pin male/female connector arrangement with 1.5 mm² copper conductors and an SJT wire designation.
Identify the two IEC connections
The C20 and C19 ends define the required supply and equipment interfaces. Compare both mating connections with the actual power arrangement, including their orientation and the clearance available around the connector bodies, before selecting the short lead.
- The C20-to-C19 pairing identifies both ends of the extension.
- A 0.5 m reach gives the cable request a specific length.
- The black configuration matches the actual selectable finish.
- 1.5 mm² specifies the featured copper-conductor size.
- The SJT designation identifies the stated cable family.
Measure the short UPS or PDU route
The featured half-metre length is approximately 1.64 ft and should be assessed along the intended cable path. For a computer or power-distribution layout, include the position of each IEC connection and the reach needed between them, rather than relying only on a straight-line equipment separation.
Match the load to the complete cord
The electrical designation is 250 V, 16 A for the specified IEC connection pair. Confirm the complete ordered assembly rating and match it to the equipment demand, then keep the 1.5 mm² copper build and required connector positions together in the inquiry. A connection drawing can clarify the intended C20/C19 arrangement for a short UPS or PDU lead and make the half-metre requirement easier to assess.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
