Series illustrations. Actual configuration is subject to the confirmed drawing.
0.3m US 3-Prong Power Splitter for Dual Locking Female Stage/LED/Audio Connections
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
End connectionNEMA AC connection
-
AC Outlets Quantity1 OutletsCable Length0.3 m(0.98ft)
-
End TypeNEMARated Current15 A
-
TypeAc Power Cord
-
ApplicationHome ApplianceFemale End TypeOther
-
IP LevelIP48Male End TypeNema
-
MaterialPVCWire TypeSJTW
A short US supply lead can be specified around the stage devices that need the split connection. This power splitter request pairs a US three-prong plug with dual locking-female connections for LED-screen and audio-equipment use, with the finished output arrangement to be confirmed.
Draw the split before selecting the cord
Identify how many locking outputs are required, the mating interface at each device and the length of each branch. Confirm those details on the final assembly drawing so the requested split feed describes a specific physical arrangement.
- The cable length is stated as 0.3 m, or 0.98 ft.
- The actual selectable colour and plug version are black and US.
- PVC is the stated material.
- SJTW identifies the wire type.
- Available cross sections are 0.75, 1.0, 1.5 and 2.5 mm².
Use the complete load requirement
A 15 A designation is given for the cord. Provide the connected equipment demands and establish the selected assembly's permissible total and branch loads, rather than treating each output as an independent source of the full current designation.
Check supply, locking ends and exposure together
Match the US plug to the intended supply connection and confirm the required operating voltage. Then check each locking-end profile against its equipment inlet. If the installation requires protection against environmental exposure, specify that requirement for the entire plug, branch and connector arrangement. Include the selected area, output drawing and required service conditions in the enquiry so the compact splitter is defined around the actual equipment layout.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
