A two-pin SAE quick-connect/disconnect arrangement defines this DC extension lead. The stated construction uses an 18AWG copper core with PVC insulation and jacket, a 24 V designation and an actual two-core, 2P configuration.
Choose the reach for the equipment route
Length requests are 1 ft, 6 ft and 8 ft. Identify the finished reach and both receiving connections for the RV, solar-panel, motorcycle, battery-maintainer, boat or tractor application being considered.
- SAE identifies the specified connector arrangement.
- Two pins and two cores are the actual configuration.
- 18AWG is the stated wire gauge.
- Copper core and PVC define the conductor and insulation materials.
- The jacket is also specified as PVC.
Match the DC connections and circuit requirements
Confirm the physical mating arrangement and polarity at each end against the intended equipment. Provide the actual voltage and load with the route details so the selected lead can be checked as one complete connection.
Define any protection or endurance acceptance
For an IP44 requirement, identify the complete-assembly and mated-connection conditions that must apply. If a flex-life reference of at least 100,000 is required, request the applicable test method, bend geometry and duty conditions for the chosen lead. Include these requirements with the exact length and connector drawing when preparing the enquiry. This gives the extension request a specific electrical and physical scope for the selected equipment route.
