Series illustrations. Actual configuration is subject to the confirmed drawing.
1m–2m Australian 2-Pin Plug to IEC C7 Figure-8 Extension Power Cord
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
End connectionIEC C7
-
AC Outlets Quantity1 OutletsCable Length0.5 m, 1m, 1.2 m, 1.5 m, 1.8 m , 1.83 m, 2 m
-
End TypeC7Rated Current10 A
-
TypeAc Power Cord
-
ApplicationHome Appliance, Computer, Consumer Electronics, Industrial Equipment, Instrumentation, TelecommunicationFemale End TypeIEC
-
IP LevelIP11Male End TypeAS
-
MaterialCopper, PVCWire TypeH03VVH2-F 0.75MM
-
Product nameSAA Approval C7 Power CordPlugAU 2pin
-
ConnectorIEC C7Length1m 1.5m 1.8m or can be customized
-
CableH05VV-F 3G*0.75/1.0/1.5mm2ConductorCopper, CCA, CCS
-
ColorBlack, WhiteJacketPVC
-
CertificationSAA, RoHSWarranty12 Months
The Australian two-pin plug and IEC C7 figure-eight connection identify this appliance power lead. Actual black and white choices are paired with a PVC jacket, while the required cable reach and construction should be selected for the receiving equipment.
Match the Australian and C7 interfaces
Compare the supply plug and C7 equipment connection with the actual appliance or computer installation. Include connector orientation and nearby clearance in the inquiry, so the lead is specified around the required physical mating points.
- An Australian two-pin plug defines the supply-side requirement.
- The IEC C7 figure-eight end identifies the equipment connection.
- Black and white provide two actual selectable finishes.
- A PVC jacket retains the stated outer cable material.
- Custom reach can be requested alongside the named metric lengths.
Specify the finished cable length
Length requests include 0.5 m, 1 m, 1.2 m, 1.5 m, 1.8 m, 1.83 m and 2 m. Measure the route followed by the lead and state the required finished reach, including connector clearance at both ends. The selected colour and length should refer to the same ordered AU/C7 configuration.
Agree the exact electrical build
The cord has a 10 A designation, and the complete voltage and current rating should be confirmed for the chosen assembly. Specify the cable family, conductor composition and actual wire count with the receiving equipment demand. A drawing that links those construction details to the two-pin plug, C7 end and selected reach gives this Australian appliance lead a complete configuration for quotation.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
