Single-Core XLPE SWA Armoured Power Cable Copper/Aluminum PVC Sheath 0.6/1kV 16–300mm2

This low-voltage electrical power cable family combines XLPE insulation, a PVC sheath and steel-wire armour at 0.6/1kV. Copper or aluminium conductor choices and a 16–300mm2 section range are available as family references. Complete the single-core construction selection with an exact conductor material, section and approved circuit-specific armour arrangement before finalizing the order.

Select the conductor material and exact section

State whether the required cable uses copper or aluminium, together with the exact conductor section within the 16–300mm2 range. Put those selected values on the circuit and material drawings. Keep the chosen conductor and connection requirements together when the proposed single-core cable and compatible ends are reviewed.

Confirm the full single-core armour arrangement

Agree the selected steel-wire-armoured construction using the intended circuit and installation requirements. Carry XLPE insulation and the PVC sheath into that complete drawing. Obtain applicable installation and preparation information for the approved build, then match the final cable-end details and equipment connections to the confirmed construction.

Review the route and acceptance request

Describe the intended route and review the access and connection space needed at the equipment. Keep the selected conductor material, section and full armour arrangement available during this assessment. If the project has a precise acceptance criterion, identify it and request documents corresponding to the chosen cable construction.

Complete the physical quantity schedule

A physical 1m (3.28ft) option is provided for this family. State the required cut lengths and quantities with agreed end allowances after the full cable configuration is settled. Keep those measurements separate from the conductor-area range and include compatible ends, the approved drawing and applicable installation details in the order.