Series illustrations. Actual configuration is subject to the confirmed drawing.
European 2-Pin CEE7/16-to-C7 Figure-8 Power Cord, 0.5m 0.75mm² Copper Cable
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
AC Outlets Quantity1 OutletsCable Length0.5 m(1.64ft)
-
End TypeCEE 7/16Rated Current7A
-
TypeAc Power Cord
-
ApplicationHome ApplianceFemale End TypeCEE
-
IP LevelIP11Male End TypeCEE
-
MaterialCopperWire Type0.75MM
The figure-eight equipment connection and European CEE 7/16 reference identify this short appliance power-cord request. A black EU configuration with 0.75 mm² copper conductors and a 0.5 m reach gives the buyer a defined cable size, finish and starting length.
Confirm the European connector arrangement
Check the actual supply-plug form and the C7 equipment-end mating shape against the appliance. Include both connection references in the request so the required figure-eight lead is identified by its physical interfaces, rather than by a broad European power-cord name alone.
Fit the half-metre reach to the appliance
The 0.5 m cable length is approximately 1.64 ft and should follow the intended route between the two connections. Allow for connector clearance and the position of the appliance inlet when assessing whether this short lead reaches the required points.
- The EU configuration defines the regional supply-side request.
- The CEE 7/16 reference helps identify the required plug form.
- A C7 figure-eight connection defines the equipment-end requirement.
- 0.75 mm² copper specifies the featured conductor configuration.
- The black 0.5 m version combines a specific finish and reach.
Complete the electrical specification
Confirm the voltage and current rating of the complete assembly for the intended home appliance, together with the exact connector arrangement. Include the appliance inlet reference, 0.75 mm² copper build and half-metre reach when requesting the lead. A drawing or clear connector reference can help establish the required mating form while keeping the cable selection tied to the actual appliance connection.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
