Series illustrations. Actual configuration is subject to the confirmed drawing.
YJLV32 4-Core 25mm2 Aluminum XLPE Steel Wire Armoured Power Cable 0.6/1kV IEC
-
Quotation & delivery: Include your required quantity, destination and timing in the enquiry. Confirm the selected build, lead time, shipping charges and any return terms in the agreed quotation before ordering.
-
Rated voltage0.6/1 kVInsulation materialXLPE
-
Conductor materialAluminium
-
Conductor MaterialAluminumInsulation MaterialXLPE
-
Rated Voltage0.6/1kVSizeNone
-
TypeMulti-Core Power Cable
Aluminium conductors with XLPE insulation and steel-wire armour define the YJLV32 power cable in this four-core 25mm2 selection. Its rated voltage is 0.6/1kV. Develop the full construction drawing and conductor allocation together, with equipment connections and installation requirements applicable to the selected aluminium cable build.
Link the four-core allocation to the cable ends
Show the required section, electrical duty and equipment connection of every conductor on the circuit drawing. Keep the four-core allocation and 25mm2 selection available when reviewing compatible ends for aluminium conductors. Check the space and access needed at each connection before agreeing final end preparation. The resulting circuit and connection references should describe the same conductor arrangement throughout the project documents.
Complete the steel-wire construction description
Retain aluminium conductor material, XLPE insulation and steel-wire armour on the material drawing. Agree the final outer sheath and obtain preparation and installation information for that complete construction. Use the full layer description when comparing cable alternatives against the proposed route and equipment requirements. Include the agreed cable-end arrangement in this review so the electrical allocation and material specification remain consistent.
Bring exact acceptance and quantities into the schedule
Where an IEC requirement applies, give the exact standard number, part and scope needed by the project. Obtain matching documentation for the selected cable rather than treating a general reference as a complete acceptance request. State physical cut lengths and the number of required cuts separately from the 25mm2 section selection. Include end allowances, final sheath and conductor allocation alongside the compatible cable ends in the finalized purchase schedule.
Provide the product reference, selected configuration, quantity and destination. Confirm drawings, applicable ratings and acceptance requirements for the requested build. Lead time, shipping arrangements, charges and any return conditions should be reviewed in the agreed quotation before ordering.
